NEC PA653U - Projecting Two Screens

67
4. Multi-Screen Projection
Projecting two screens
1. PresstheMENUbuttontodisplaytheon-screenmenuandselect[DISPLAY]→[PIP/PICTUREBYPICTURE].
This displays the [PIP/PICTURE BY PICTURE] screen in the on-screen menu.
2. Select[SUBINPUT]usingthe▼/▲buttons,andpresstheENTERbutton.
This displays the [SUB INPUT] screen.
3. Selecttheinputsignalusingthe▼/▲buttons,andpresstheENTERbutton.
* This screen belongs to a HDBaseT model.
The [PIP] (PICTURE IN PICTURE) or [PICTURE BY PICTURE] screen set up under [MODE] is projected. (→
page 101)
• Whenthesignalnameisdisplayedingrey,thismeansthatitcannotbeselected.
• ThesignalcanalsobeselectedbypressingthePIPbuttonorPBP/POPbuttonontheremotecontrol.
4. Press the MENU button.
The on-screen menu will disappear.
5. Whenreturningtosinglescreen,displaythe[PIP/PICTUREBYPICTUE]screenonemoretimeandselect
[OFF]inthe[SUBINPUT]screenoftheStep3.
TIP:
• Duringdual-screenprojection,iftheselectedinputisnotsupportedbythesub-screen,thesub-screenwillappearasablack
screen.