SL1000 Getting Started Guide
11
Unpacking
Unpacking the 1632M-A KSU and check against the following list. Inspect physical damage.
Items Q’ty Remarks
1632M-A KSU
1
IP4WW-CPU-A1, IP4WW-408M-A1 and Power
Supply is initially equipped into the 1632M-A
KSU.
AC Power Cord
1
IP4WW-1632M-A w/o C is not including the AC
Power cord.
Screw(M4.1x25)
4
These four screws are for Wall Mount.
Template for Wall Mounting
1
This is the template for Wall Mount screwing.
CD-ROM
1
User Manual data are inside.
Necessary Tools (Not Supplied)
Make sure the necessary tools are prepared.
Required Items Specification
Telephone Cables
Recommended cable type:Twisted Pair
Conductor diameter: 0.4 to 0.6 mm
Maximum cable length (with 0.5mm diameter
cable):
SL1000 system Telephone/DSS Console --- 300 meters
Analog Telephone --- 1125 meters
RJ11 Plugs
Fixing Tools for RJ11 Plug and cable
2-conductor connectors for outside(CO) line
4-conductor connectors for extension
Cross head screwdriver
4 Wall Fixing plugs suitable for the type of wall
Replacing an Existing Telephone System
If you are replacing your existing telephone system with the SL1000, we recommend that you check the
following.
Do not disconnect all of the lines or extensions from your existing telephone system. If for any reason you
have problems installing the SL1000 you will need your old system in working order to continue your
business.
If you plan to use existing telephone cabling within your building check :
o The cable is twisted pair cable.
o There are 4 wires (2 pairs) available to each SL1000 system phone location.
o You will need an RJ11 socket for each SL1000 system phone and DSS console.
Move the exchange lines/ analog telephones one at time and test each one before moving over the next.
To Next Page
Loading...
