SL1000 Getting Started Guide
13
Wall Mount the SL1000 system
The KSU is designed for wall mounting only. The wall where the KSU is to be mounted must be able to support
the weight of the KSU.
1. Place the attached template on the wall to mark the four screw positions.
2. Install four screws into the wall. The screw heads must protrude about 2.5 to 3.5 mm.
• Wall-Mounting Screws (M4.1x 25: 4 pcs) are attached to the KSU.
3. Push the center of the Sub-Cover and slide it.
4. Pull out the Sub-Cover by opening up the tabs.
• The Sub-Cover can be opened and hold as following figure.
Wall
Template
To Next Page
Loading...
