SL1000 Getting Started Guide
30
Program22-05-01
The Incoming Ring Group (IRG) number is assigned to the Outside(CO) lines.
Different IRG’s can be assigned to each exchange line to give different ring assignment throughout the day.
Default Setting:
Each Line (CO1-CO4) is assigned to incoming Ring Group (IRG) number 1.
There are up to 8 settings available.
IRG number 1 is used for all 8 settings.
Therefore, each exchange line will ring at IRG 1 and therefore telephone number 200, regardless of the time of
day.
Operation Display shows;
1. After Log-In to the Programming Mode.
2. Dial 22 05 01. Change the Trunk Number(1-4) if require.
3. Press DND/CONF key to move the cursor to Mode Number.
Change the Mode Number(1-8) if requre,
4. Press DND/CONF key to move the cursor to IRG Number. Change
the IRG Number(1-25) if you require.
5. Press Hold key to confirm the entry and step to the next option.
6. Press Mute key several times when you are done to return to the
Program Mode.
7. Press Speaker key to save changes and exit from the Programming
Mode.
Program22-04-01
The telephones are placed into Ring Group(IRG’s).
Default Setting:
Telephone Number 200 is a member of IRG number 1.
Operation Display shows;
1. After Log-In to the Programming Mode.
If you already Log-In the programming mode, skip this operation.
2. Dial 22 04 01. Change the Incoming Ring Number(1-25) if require.
3. Press DND/CONF key to move the cursor to Member Number.
Change the Member Number(01-32) if requre.
4. Press DND/CONF key to move the cursor to Extension Number.
Change the Extension Number(200-) if you require.
5. Press Hold key to confirm the entry and step to the next IRG member.
6. Press Mute key several times when you are done to return to the
Program Mode.
7. Press Speaker key to save changes and exit from the Programming
Mode.
Program Mode
22-05-01Trunk1
Model1 IRG=1
22-05-01Trunk1
Mode1 IRG=1
22-05-01Trunk1
Mode1 IRG=1
Program Mode
22-04-01INC Gr1
Memb.01= 200
22-04-01INC Gr1
Memb.01= 200
22-04-01INC Gr1
Memb.01= 200
To Next Page
Loading...
