UNIVERGE SV8100 Issue 1.0
System Maintenance Manual 3 - 17
[RegId20][UserId:] not REGISTERED to SIP Server(1/30 8:50)
[RegId21][UserId:] not REGISTERED to SIP Server(1/30 8:50)
[RegId22][UserId:] not REGISTERED to SIP Server(1/30 8:50)
[RegId23][UserId:] not REGISTERED to SIP Server(1/30 8:50)
[RegId24][UserId:] not REGISTERED to SIP Server(1/30 8:50)
[RegId25][UserId:] not REGISTERED to SIP Server(1/30 8:50)
[RegId26][UserId:] not REGISTERED to SIP Server(1/30 8:50)
[RegId27][UserId:] not REGISTERED to SIP Server(1/30 8:50)
[RegId28][UserId:] not REGISTERED to SIP Server(1/30 8:50)
[RegId29][UserId:] not REGISTERED to SIP Server(1/30 8:50)
[RegId30][UserId:] not REGISTERED to SIP Server(1/30 8:50)
[RegId31][UserId:] not REGISTERED to SIP Server(1/30 8:50)
-----------------------------------
Enter Function DIM Output
IP GW Displays the SV8100 Default
Gateway (PRG10-12-03)
[ Default Gateway ] : 192.168.1.254
IP ARP Displays the SV8100 ARP
(Address Resolution
Protocol) cache. This is a
table of MAC address to IP
Address mappings.
See below
IP ROUTE Displays the SV8100 routing
table. Usually this will
consist of just a few entries,
as the default gateway is
used for any traffic destined
for a different IP subnet.
See below
IP DSP INFO This shows how many DSP
channels are in use at a
particular moment in time.
See below.
IP DSP INFO 1 This shows how many DSP
channels are in use at a
particular moment in time for
all device types.
See below.
Ping <ip address> The commonly used “ping”
utility has been implemented
on the CD-CP00-US. This is
a very useful fault finding
tool.
VoIPU >ping 192.168.11.200
Pinging 192.168.11.200 with 32 bytes of
data:
Reply from 192.168.11.200:
Reply from 192.168.11.200:
Reply from 192.168.11.200:
Reply from 192.168.11.200:
Ping statics for 192.168.11.200:
Packets: Sent = 4, Received = 4,
Lost = 0 (0% loss):
To Next Page
Loading...
