What to do if NEC VT580 shows lamp cover error?
If your NEC Projector displays a lamp cover error, try the following: Ensure the lamp cover or lamp housing is correctly replaced. If the issue persists, move the projector to a cooler area. Allow the projector to sit for a minute before attempting to power it on again. Also, you may have pressed the cabinet button when it is locked. If none of these steps work, consider replacing the lamp.
General| Display resolution | 1600 x 1200 pixels |
|---|---|
| Vertical scan range | 50 - 120 Hz |
| Horizontal scan range | 15 - 100 kHz |
| Contrast ratio (typical) | 600:1 |
| Screen size compatibility | 76.2 - 762 \ |
| Projector native resolution | XGA (1024x768) |
| I/O ports | VGA, S-Video, Composite, Monitor Out, Audio In x2, Audio Out, RS-232 |
| Interface | USB |
| Aspect ratio | 4:3 |
| Dimensions (WxDxH) | 309 x 258 x 112 mm |
| Power requirements | 100-120/200-240VAC 50/60Hz |
| Lamp power | 200 W |
| Light source type | Lamp |
| Service life of light source | 3000 h |
| Number of built-in speakers | 1 |
| Noise level | 35 dB |
| Power consumption (standby) | 7.4 W |
| Power consumption (typical) | 280 W |
Weight and Dimensions| Weight | 2900 g |
|---|
Essential safety warnings for projector use, installation, and handling.
Warnings for California residents, RF interference, and critical safeguards.
Detailed precautions against electrical hazards, fire, and safe installation practices.
Instructions for connecting PCs, DVD players, VCRs, and other video devices.
Procedure for turning on the projector and initial setup steps.
How to choose the active video or computer input signal for display.
Steps for properly powering down the projector and allowing it to cool.
Step-by-step guide for safely replacing the projector lamp and resetting the hour meter.
A checklist to diagnose and resolve common projector issues.
Detailed technical data on the projector's optical, electrical, and mechanical features.
To Next Page
