17
© by NECTA VENDING SOLUTIONS SpA 02-2004 184 02
TECHNICIAN MENU
The machine control software includes all of the possible
functions for the range. According to the machine model
and configuration some functions are not physically avail-
able and therefore are deactivated.
When pressing button “ ” from “Filler” mode, the machine
is preset to “technician menu”.
The first option of the programming menu is displayed,
enabling the following functions:
Failures Reading present failures
Delete
Prog. parameters
Cash Prices
Coin mechanisms
Decimal point
Master/Slave
Selections Water doses
Powder doses
Accessories
Selection status
Button-Selection
Selection position
Product code
Machine parameters
Boiler temperature
Tank
Mixer heating
Mixers cooling
Fast cycles
N. of maintenance
selections
Cup sensor
Slider time
Column rotation time
Mok-cap wash
Wash button
Automatic wash
Decaf cycle
Pre-grinding
Brewing time
Display Language
Promotional message
Custom messages
Pre-selections No cup
Extra sugar
Sugar
Less sugar
More sugar
More water
Less water
More powder
Less powder
Coffee 2
Extra milk
More Jug
Less Jug
Mokka
Miscellaneous Jug facilities
Password
Filler menu
Energy saving
Position of wash spouts
Statistics Electr. counters reading
deleting
Display Selection counters
Counters by time bands
Discount counters
Failure counters
Coin mechanisms
Delete partial
total
Display relative Selection counters
Counters by time bands
Discount counters
Failure counters
Coin mechanisms
Delete relative partial
total
Display counter at start-up
Print partial
total
Print relative partial
total
Test Dispensing complete
water only
powder only
without accessories
accessories only
Special functions Unit rotation
Dose release
Boiler emptying
Manual installation
Autotest Actuation in sequence of:
.doser devices
.mixers
.cup dispenser
.stirrer dispenser
.fluorescent lamps
.door LED
.push-buttons
.mobile spouts
.coffee dose
.unit rotation
.waste container switch
To Next Page
Loading...
