KORO ESPRESSO
C
LEANING
/ L
OADING
L
OADING
R
EGULAR CLEANING
R
EGULAR CLEANING
Loading products:
• Open the dispenser door.
• Lift the lid and open the instant powder container’s lid (A).
• Load the product in (A), taking care not to compact the instant
powder.
• Load container (B) with coffee beans.
1
B
A
Filling up the water supply tank:
• Remove the liquid waste tray.
• Remove the water tank (A) by pulling on its handle.
• Fill the tank with drinking water up to the maximum level (B).
• Fit both the water tank and the liquid waste tray back into place.
2
B
A
Emptying the liquid waste tray:
When the red float signal lifts up through the grille, it is necessary to
empty the liquid waste tray immediately. The dispenser will then
work normally. It is advisable not to wait until the red drip tray full
indicator is visible. It is recommended that the liquid waste tray
is emptied regularly.
1
Emptying the liquid waste tray:
• Take hold of the sides of the liquid waste tray (A) firmly, then lift
slightly and pull forward.
• Empty the tray and if necessary, wash it using a mild detergent
solution.
• Re-fit the tray back into position.
2
A
Emptying the solid waste tray:
When the “W
ASTE TRAY FULL
” message appears on the display, the
solid and liquid waste trays require emptying:
• Take hold of the sides of the liquid waste tray firmly, lift and pull.
• Remove the solid waste tray (A) and empty it.
• Fit both the solid and the liquid waste trays back into position.
3
A
Rinsing the mixer:
• Press and hold the last selection button for 3 seconds.
• When “Password” appears on the display.
• Enter password for rinse function.
The mixer rinsing cycle must be carried out regularly or after
loading the instant powder.
4
ON
ON
W
ASTE
TRAY FULL
ON
ON
To Next Page
Loading...
