Necta Koro Espresso - Cleaning the Milk Circuit

C LEANING THE MILK CIRCUIT
1 2
• At power-on and during a mixer rinse the machine proposes the
steps to be carried out for washing the milk circuit.
• It may be useful to place a container under the spouts for collect-
ing the liquid residue from washing.
• Take the priming tube out of the fresh milk container.
• Press the confirmation button (third one) to continue.
L
C
E
N
A
R
E
3
L
C
E
N
A
R
E
4
• Insert the priming tube in a container with a detergent solution.
• Press twice the confirmation button (third one) to start the clean-
ing cycle.
• Take the priming tube out of the container with the solution used.
• Press the confirmation button (third one) to continue.
A
W
T
R
E
5
A
W
T
R
E
6
• Insert the priming tube in un container with clean water.
• Press twice the confirmation button (third one) to start the rinse
cycle.
• Replace the priming tube in the fresh milk container.
• Press the confirmation button (third one) to complete.
• Empty out all washing residue from the liquid waste container.
CAPPUCCINATORE
C LEANING OF THE MILK CIRCUIT MUST BE CARRIED
OUT AT THE END OF USE
.
D O NOT USE DETERGENTS THAT ARE
TOO SCENTED
.
R INSING MUST ALWAYS BE CARRIED OUT
AT THE END OF THE CLEANING CYCLE
.
REMOVE MILK
CONFIRM?
INSERT DETERGENT
CONFIRM?
DETERGENT CYCLE
CONFIRM?
REMOVE DETERGENT
CONFIRM?
INSERT WATER
CONFIRM?
INSERT MILK
CONFIRM?
CLEAN CYCLE
CONFIRM?