ANPR
© Nedap AVI, P.O. Box 103, NL-7140 AC GROENLO Page 22 of 27
5.3 SYSTEM CONFIGURATION
5.3.1 NETWORK
The Network Settings page contains the following configuration fields:
Network
NetBiosName It allows setting the name of the ANPR device. It is possible to enter alphanumeric
values in this field. Spaces must be represented by "_" (underscore).
IpAddress It allows setting the IP address of the ANPR device.
NetMask It allows setting the network net mask.
Gateway It allows setting the gateway IP address.
DhcpEnable It allows enabling/disabling automatic acquisition of IP addresses.
Time Server
Syncro This feature enables/disables the synchronization to an external timeserver.
IpAddress Indicates the IP address of the time server which is used as reference to synchronize
the ANPR's internal clock.
GMT Offset Indicates the number of minutes to add to the time received from the time server, in
order to offset between "Greenwich Mean Time" and local time. This value is
expressed in minutes and can be negative. See
http://wwp.greenwichmeantime.com
for further details on time zones for different countries around the world.
Auto DST Automatically adjust clock for daylight saving changes. If set to YES, it automatically
handles switching between daylight-saving time and standard time.
5.3.2 HTTP USERS
Three user access levels are available:
• Superuser The superuser is allowed to access all system-enabled features, modify operational
parameters (setup) and assign access rights to other users.
• Administrator The administrator has the rights to modify any all operational parameters but is not
allowed to access the HTTP Users page.
• Guest Guest users are only allowed to view the system parameters.
Access to HTTP Users page is granted to the superuser only, who is allowed to enable, disable or delete users or
to assign new passwords. Up to ten administrator and/or guest users can be assigned to the system and only one
superuser account.
The HTTP Users page contains the configuration settings of the users who access the ANPR via a browser.
Server Port: The port number where the http server is open. Default value is 80.
Name: User's username.
Password: User's password.
Status: User's access level. Can be ADMIN, GUEST or DISABLED.
To Next Page
Loading...
Need help?
General
