Nedap SmartFlow - Page 29

Nedap SmartFlow / Installation manual
Version 00.001 / September 2020 / EN
27
Dairy Farming
2. In the column Approved, check that the SmartFlow has been approved. The SmartFlow is approved when
the deviation is in the range 97% - 103%.
a. SmartFlow ok indicates that the SmartFlow is approved: No further action is needed. The SmartFlow is
ready to use.
b. SmartFlow not ok indicates that the SmartFlow is not approved: Check the SmartFlow in the milking
parlor for technical issues.
1. The SmartFlow is technically fine: Perform a zero-point test and calculate a new correction value
using the milk test (see Milk test (page 25)).
2. The SmartFlow is technically not fine: Fix the SmartFlow. Next perform a zero-point test and
calculate a new correction value using the milk test (see Milk test (page 25))