en Drying
24
18 Drying
To prevent residual moisture, dry the cooking compart-
ment following microwave-only operation.
18.1 Drying the cooking compartment
WARNING‒Risk of burns!
The appliance becomes hot during operation.
▶ Allow the appliance to cool down before cleaning.
ATTENTION!
If there is water on the cooking compartment floor
when operating the appliance at temperatures above
120°C, this will damage the enamel.
▶ Do not use the appliance if there is water on the
cooking compartment floor.
▶ Wipe away any water on the cooking compartment
floor before operation.
Requirement:The cooking compartment has cooled
down.
1.
Remove any food remnants from the cooking com-
partment.
2.
Dry the cooking compartment with a sponge.
3.
Remove limescale marks with a cloth soaked in vin-
egar, then wipe with clean water and dry with a soft
cloth.
4.
Leave the cooking compartment to dry with the ap-
pliance door open for 1hour or use "Drying func-
tion".
→"Setting 'Drying function'", Page24
18.2 Setting "Drying function"
Requirement:→"Drying the cooking compartment",
Page24
1.
Press "Cleaning".
2.
Press "Drying function".
a The duration appears on the display. You cannot
change the duration of the drying function.
3.
Start the drying function using
.
a A notification stating that you should carry out the
necessary preparatory work for the drying function
appears on the display.
4.
Press "OK" to confirm the notification.
a The drying function starts. The duration counts down
on the display.
a Once the drying function has run through to the
end, an audible signal sounds.
5.
Leave the appliance door open for 1-2minutes so
that the cooking compartment dries completely.
19 Rails
To thoroughly clean the rails and the cooking compart-
ment, or to replace the rails, you can remove the rails.
19.1 Detaching the rails
WARNING‒Risk of burns!
The shelf supports get very hot
▶ Never touch the shelf supports when hot.
▶ Always allow the appliance to cool down.
▶ Keep children at a safe distance.
1.
Lift the rail forwards and detach it .
2.
Swivel the entire rail outwards and unhook it at
the rear .
19.2 Fitting the retainers
The retainers may fall out when you detach the rails.
Note:
The retainers at the front differ from those at the rear.
1.
Hook the front retainers with the hook into the round
hole at the top and set them at a slight angle .