12
Descaling
The appliance must be descaled at regular intervals in order for
it to continue operating correctly. The
Í indicator reminds you
to do this.
You can only dispense with descaling completely if you
exclusively use softened water.
The descaling operation consists of:
■ Descale (approx. 30 minutes), then refill the water tank and
empty the evaporator dish
■ 1st rinse (30 seconds) and then empty the evaporator dish
■ 2nd rinse (30 seconds) and then remove the remaining water
All three steps must be completed in full. The appliance is
ready for operation again only after the 2nd rinse.
Descaler
Only use the liquid descaler recommended by the after-sales
service for descaling (product no. 311138, also available
online from the eShop). Other descalers may damage the
appliance.
1. Prepare a descaling solution by mixing 300 ml water and
60 ml liquid descaler.
2. Empty the water tank and fill with descaling solution.
3. Carefully slide in the water tank with the descaling solution
and close the appliance door.
Caution!
Risk of surface damage: If descaler comes into contact with the
front of the appliance or any other sensitive surfaces, wash it off
immediately with water.
Caution!
Damage to the appliance: If descaler is in the appliance for a
prolonged period, this may damage the water pump. Ensure
that the descaling and rinsing cycles take no longer than three
hours to complete.
Starting descaling
The cooking compartment must have cooled down completely.
1. Press the ~ main switch to turn on the appliance.
2. Press the Í button.
The
Î symbol (Fill water tank) is displayed. This is to remind
you to fill the water tank with the descaling solution (see
section: Descaler).
3. Press the … button.
1st rinse
A signal sounds after approx. 30 minutes. The
Î symbol (Fill
water tank) and
x ‚:‹‹ min are displayed.
1. Rinse the water tank thoroughly, fill with water until the MIN
mark and reinsert.
The
Ì symbol (empty evaporator dish) appears.
2. Remove the descaling solution from the evaporator dish
using the cleaning sponge supplied.
3. Close the appliance door and press the … button.
The appliance starts rinsing.
2nd rinse
After a short time, the
Ì symbol appears again. x ‹:„‹ min
appears in the display.
1. Thoroughly rinse out the cleaning sponge.
2. Remove the remaining water from the evaporator dish using
the cleaning sponge.
3. Close the appliance door and press the … button.
The appliance starts rinsing.
Once descaling is complete,
‹‹:‹‹ and Ì appear in the
display.
4. Press the ~ main switch to finish descaling and switch off
the appliance.
Removing the remaining water
Remove the remaining water from the evaporator dish using the
cleaning sponge. Wipe out the cooking compartment using the
cleaning sponge and then dry with a soft cloth.
Cancelling the descaling
1. Press and hold the … button.
Descaling is cancelled.
To ensure that no descaling solution remains in the
appliance, it must be rinsed twice after a cancellation.
2. Press the … button.
The
Î symbol appears.
Now proceed as described in the “1st rinse“ section.
To Next Page
Loading...
Need help?
General