NEFF C44L20N0 User Manual

13
Troubleshooting
Malfunctions often have simple explanations. Please read the
following instructions before calling the after-sales service.
Repairs may only be carried out by fully trained after-sales
service technicians. Incorrect repairs to your appliance may
present considerable risks for the user.
ã=Risk of electric shock!
■ Work on the appliance electronics may only be performed by
a specialist.
■ Always disconnect the appliance from the power supply
when work is carried out on the electronics. Switch off the
circuit breaker or remove the fuse from your household fuse
box.
Problem Possible cause Notes/remedy
The appliance does not work The plug is not plugged in. Connect the appliance to the electricity
supply
Power cut Check whether other kitchen appliances
are working
Fuse defective Check in the fuse box to make sure that
the fuse for the appliance is OK
Faulty operation Switch the appliance off using the fuse in
the fuse box. Wait approximately
10 seconds and then switch it back on
The appliance cannot be started The appliance door is not fully closed Close the appliance door.
Appliance does not start.
x and ‚:‹‹
min appear in the display
Descaling has been cancelled Rinse the appliance twice
(see section: Cancelling descaling)
‹‹:‹‹ lights up in the display
Power cut Reset the time of day (see section: Setting
the clock)
The appliance is not in operation.
x
appears in the display, and a cooking time
The … button was not pressed after
setting
Press the … button to start, or press the
~ main switch to turn off the appliance
The appliance is not in operation. The time
of day is not shown in the display.
The clock display is switched off Switch on the clock display (see section:
Changing the time of day; switching the
clock display on and off)
The
Î (Fill water tank) indicator appears,
even though the water tank is full
The water tank has not been inserted
properly
Slide in the water tank until it engages.
The detection system is not working Descale the appliance (see section:
Descaling) and check which water
hardness has been set (see section:
Setting the water hardness range)
It is difficult to engage the water tank Rubber seal on the water tank valve Lightly grease the rubber seal with
lubricant (order no. 311 168)
The evaporator dish has boiled empty
even though the water tank is full.
The water tank has not been inserted
properly
Slide in the water tank until it engages
The feed line is blocked Descale the appliance (see section:
Descaling).
Check whether the water hardness range
is set correctly
The evaporator dish is overflowing The evaporator dish was not emptied after
the last cooking operation
Use the enclosed cleaning sponge to
empty the evaporator dish after every
cooking operation
Extremely loud pumping sound during
cooking
Water tank is empty, but water is still
evaporating in the evaporator dish
Filling the water tank
The water tank has not been inserted
properly
Slide in the water tank until it engages
Pumping sound during cooking This is normal
There is a "pop" noise during cooking Cold/warm effect with frozen food, caused
by the steam.
This is normal
When you cook with steam, a lot of steam
is created
The appliance is being automatically
calibrated
This is normal (see section: Automatic
calibration)
When cooking with steam, a lot of steam is
created again
The appliance is unable to calibrate itself
automatically if cooking times are too
short
Restore the appliance to factory settings
(see section: Basic settings) and
recalibrate the appliance (see section:
Before first use)
Steam escapes from the ventilation slots
during cooking
This is normal

NEFF C44L20N0 Specifications

General

Brand	NEFF
Model	C44L20N0
Category	Oven
Language	English