8
Preset operation
The appliance switches on automatically, then switches off
automatically at the time preselected for the end of operation.
To set this function, combine the cooking time and end of
operation clock functions.
Bear in mind that food which spoils easily should not be left in
the cooking compartment for too long.
1. Set the operating mode and temperature.
The appliance heats up.
2. Press the KJclock function button repeatedly until
the KJand x symbols light up.
3. Set the cooking time with the rotary selector
(e.g. ‚:„‹ hours).
The setting is applied automatically.
4. Press the KJclock function button repeatedly until
the KJand y symbols light up.
5. Set the end of operation using the rotary selector
(e.g. ‚ƒ:„‹ o'clock).
The appliance switches off and waits until the appropriate
time to switch on (‚‚:‹‹ in the example). The appliance
switches off automatically at the time set for the end of
operation (
‚ƒ:„‹ ).
6. Turn the operating mode and temperature selector back to
the
Û position.
7. Press the KJ clock function button to exit the clock function.
Setting the clock
You can only change the clock when no other clock function is
active.
1. Press the KJ clock function button repeatedly until
the
KJand 3 symbols light up.
2. Set the clock using the rotary selector.
The setting is applied automatically.
Rapid heat up
With 3 CircoTherm®, you can shorten the heat up time if your
selected temperature setting is higher than 100 °C.
Note: During Rapid heat up, do not place any food in the
cooking compartment for as long as the f symbol is lit.
1. Set the operating mode and temperature.
The appliance heats up.
2. Press the KJ clock function button repeatedly until the KJ
and f symbols light up and Πappears in the clock display.
3. Turn the rotary selector clockwise.
In the clock display,
Ž is displayed and the f symbol lights
up. Rapid heat up is activated.
After reaching the set temperature, Rapid heat up switches off.
The f symbol goes out.
Checking, correcting or deleting settings
1. To check your settings, press the KJ clock function button
repeatedly until the corresponding symbol lights up.
2. If necessary, you can correct your setting using the rotary
selector.
3. If you wish to cancel your setting, turn the rotary selector anti-
clockwise to the original value.
Baking
In this section, you will find information on
■ Baking tins and trays
■ Baking on two or more levels
■ Baking basic doughs and cake mixtures (baking table)
■ Baking pre-prepared frozen products and freshly prepared
meals (baking table)
■ Tips and tricks for baking
Note: Do not use shelf height 2 when baking with
3
CircoTherm®. The air circulation would be impaired and this
will have a negative effect on your baking.
Baking in tins and on trays
Baking tins
We recommend that you use dark baking tins made from metal.
Tinplate and glass dishes increase the baking time required
and the cake will not brown evenly. If you wish to bake using
tinplate tins and
% Top/bottom heat, you should use shelf
height 1.
If you are baking on one level with
3 CircoTherm®, always
place a loaf tin diagonally (Fig. A) and a round tin in the centre
of the stepped wire rack (Fig. B).
To Next Page
Loading...
Need help?
General