77
Fitting the shelf support To refit the shelf support, proceed as follows:
1. Position the bottom part of the shelf support on the
respective pins.
2. Push the upper part against the oven side wall until
it hooks into the upper pin.
Faults and after-sales service
If a fault occurs, it is often only due to a small thing.
Before calling the after-sales service, please see the
following notes.
Repairs must only be carried out by trained
after-sales service engineers.
If your appliance is not properly repaired, this may
cause serious risks to you.
Fault Possible cause Notes on remedial action
The appliance is not working. Defective fuse Check in the fuse box that
the fuse for the appliance is
in order.
Power failure Check whether the kitchen
light is working.
The clock display is flashing. Power failure Reset the time.
The oven light is not working. Defective oven light
bulb
Replace the oven light bulb.
(see the following section
"Replacing the oven light
bulb")
To Next Page
Loading...
