Installation instructions en
33
Food Accessories/cookware Shelf pos-
ition
Type of
heating
Temperature in
°C
Cook-
ing time
in mins
Small cakes, 2levels Universal pan
+
Baking tray
3 + 1 140
1
30-40
Small cakes, 3levels Universal pan
+
Baking tray
4 + 3 + 1 140
1
30-40
Hot water sponge cake Springform cake tin,
diameter 26 cm
2 160-170
2
25-35
Hot water sponge cake Springform cake tin,
diameter 26 cm
2 160-170 30-35
Hot water sponge cake, 2levels Springform cake tin,
diameter 26 cm
3 + 1 150-160
2
35-50
1
Preheat the appliance for five minutes. Do not use the rapid heating function.
2
Preheat the appliance. Do not use the rapid heating function.
Recommended settings for grilling
Selection for the main oven
Food Accessories/cookware Shelf pos-
ition
Type of
heating
Temperature in
°C/grill setting
Cook-
ing time
in mins
Toasting bread Wire rack 4 /
1
5–6
1
Do not preheat the appliance.
Recommended settings for grilling
Selection for the top oven
Food Accessories/cookware Shelf pos-
ition
Type of
heating
Temperature in
°C
Cook-
ing time
in mins
Browning toast Wire rack 3 4-6
21 Installation instructions
Observe this information when installing the appliance.
21.1 General installation instructions
Follow these instructions before you start with
the installation of the appliance.
¡ The safe operation of this appliance can
only be guaranteed if it has been installed
to a professional standard in accordance
with these installation instructions. The in-
staller shall be liable for damages incurred
as a result of incorrect installation.
¡ Do not use the door handle for the trans-
port or installation.
¡ The appliance must be transported by two
people using the carry handles on the right
and left.
¡ Check the appliance for damage after un-
packing it. Do not connect the appliance if
it has been damaged in transit.
¡ Before starting up the appliance, remove
any packaging material and adhesive film
from the cooking compartment and the
door.
¡ Proceed in accordance with the installation
sheets for installing accessories.
¡ Fitted units must be heat-resistant up to
95°C, and adjacent unit fronts up to
70°C.
To Next Page
Loading...
Need help?
General