Version: 9a
13.11.2018
14
EN
ATTENTION:
During the ame switching o phase and exchanger cooling, you should not switch
the stove on again until the cycle ends;
this state is signalized by the display ‘SWITCHING OFF’
ATTENTION:
If the heater is switched o, the ame will continue burn until the fuel exhaustion in
the melting pot, this will happen in automatically, this can last up to 5-8 minutes.
NOTE:
Before rst usage it is necessary to put a hand of pellets to the re pot.
NOTE:
if the ignition fails, the thermal control will shut o the stove automatically.
Meanwhile, E2 (Error for the ignition failure), will be shown on the display.
If you want to restart it, please check the stove as usually and clean the re pot.
After that, push
to clear the word E2.
Follow the above process to ignite and start again.
HOWEVER, it is possible to switch o the heater in every functioning phase.
Turning o the heater is done by pressing the button ON/OFF
for two seconds;
make sure the stove is under your supervision, until “Stabilization”.
After you push the button the word „Cooling“ will show on the display.
After the stove’s temperature sinks, the stove will start again, Cleaning-feeding-lighting-stabilization.
How to make the stove skip to the process Stabilization when you think the ame is ok and/or
the stove can work properly?
Push
for 3 seconds, and then it will turn directly to Stabilization.
The switching o phase is displayed by the message ‘SWITCHING OFF”.
This will show up to the end of the operation. Whether the heater is switched on or not.
The display will display the hour, the power, and the planned set temperature.
To Next Page
Loading...
