17
Network Camera Installation Manual
TIPS
*When you first install Micro SD card, Micro SD card required to be formatted in
the APP.
*After the camera is powered on for about 30s, the camera will rotate a circle
automatically.
*After the camera is added in LAN successfully, no further setup is required for
remote access.
*In setting up a wireless connection, please make sure the wireless signal
strength is strong.
*After the device is connected to the power and network cable, the green light
will be on and the yellow light will be blinking continuously.
*If the built-in speaker sound is too weak, you can connect to an external speakers.
*If you forget your password, you can restore the factory default settings by
resetting the camera.
To Next Page
Loading...
Need help?
General