5
Network Camera Installation Manual
Fig 2.2g
Method 3:Tap“ ” to add camera, then manually input all the information into the
system. Name your camera by your choice, input the Camera ID, then input Username
and finally input factory default password. Once all of the information have been added,
tap “Save” on the right top corner to finish adding process.
Fig 2.2h
Fig 2.2i
TIP
When the password is same as the factory default password, it will remind you (Fig 2.2i)
to modify the password for security reason. But, you may cancel it to skip the process.
3. Liveview Screen
3.1 Single Screen View
Fig 3.1a
Fig 3.1b
+
Add D evice