Nepagene ELEPO21 - 6.2 Power Supply Cord Selection

6 Additional Information
6-3
6.2
Proper Selection of the Power Supply Cord
If no power supply cord is provided, please select the proper power supply cord for the ELEPO21 by
referring to “Specifications” and “Certified Cord” below:
Warning
In case you use a non-approved power supply cord for Nepa Gene products,
Nepa Gene can no longer warrant the electrical safety of the device.

Specifications
Voltage Rating
125V AC (for 100-120V AC area) or 250V AC (for 220V AC area)
Current Rating
7A min. (for 100-120V AC area) 10A min. (for 220V AC area)
Temperature
60℃ min.
Length
3m max.
Fittings Configuration
Grounding type attachment plug cap. Opposite terminals in molded-on
IEC Configuration appliance coupling.

Table 1 Certified Cord
A power supply cord should be certified by one of the agencies listed in Table 1, or comprised of
cordage marked with an agency marking per Table 1 or marked per Table 2. The fittings are to be
marked with at least one of agencies listed in Table 1. In case you are unable to buy locally in your
country the power supply cord which is approved by one of the agencies mentioned in Table 1, please
use replacements approved by any other equivalent and authorized agencies in your country.