Neptune Systems COR-15 User Manual

COR User Guide Page 17
Click on the button when done.
The COR slider tile shows the current state of the COR output: manual OFF, AUTO, or
manual ON. The current speed of the COR is shown as a percentage. The COR tile must
be in the AUTO position for the COR to be operated under program control.
Click on the button on the OFF/AUTO/ON slider tile to configure the COR.
The larger graphical tile displays COR status as well as the current power consumption in
watts, the COR pump RPM (revolutions per minute), and the pump’s internal
temperature, expressed as a percentage. The OK message seen above is the normal
status; if there is some sort of error or abnormal condition, a message will be displayed
in red instead of the OK status, as seen here:
Additional information about COR error conditions is provided later in this guide.
For APEX Classic controllers, one tile will appear on the Classic Dashboard:

Neptune Systems COR-15 Specifications

General

Brand	Neptune Systems
Model	COR-15
Category	Water Pump
Language	English