Neptune Systems COR-15 User Manual

COR User Guide Page 28
USING A COR-20 IN STANDALONE MODE
If you want or need to operate your COR-20 in Standalone Mode rather than integrated
with your Apex, refer to the COR-20 Standalone User Guide found on the Documentation
page on the Neptune Systems web site.
To put your COR-20 into Standalone Mode:
1. Disconnect the power cord from the COR-20 power jack
2. Disconnect the AquaBus cable(s) from the COR-20.
3. If you have daisy-chained additional Apex modules, reconnect the AquaBus cable
to another module so that that those modules are reconnected to the Apex system
4. Reconnect the power cord to the COR-20 power jack.
5. Your COR-20 will now be in Standalone Mode
To return to APEX-connected Mode, simply reconnect your COR-20 to your Apex system
using an AquaBus cable.

Neptune Systems COR-15 Specifications

General

Brand	Neptune Systems
Model	COR-15
Category	Water Pump
Language	English