Nescafe barista - First Time Use and Initial Rinsing; Initial Rinsing Procedure

8 9
PREPARING BEVERAGES
Pour milk* into the supplied measur-
ing cup:
- Latte Macchiato: 60 ml
- Cappuccino: 50 ml
8
1
Pour milk into the cup.
8
2
The selected menu icon starts flash-
ing.
Touch the desired menu icon.
8
4
8
5
Place a cup. Remove drip tray when
using a Latte Macchiato glass.
8
3
When selected menu icon stops
flashing your coee is ready. All
lights are steady green. Enjoy your
coee. CAUTION! Your coee will
be hot!
8
7
Hot water/coee extraction starts and
stops automatically.
To stop the extraction partway through,
touch selected menu icon again and
wait until light stops blinking. Neverthe-
less some coee will continue to flow
as long as the icon is flashing.
8
6
Milk coee options
Latte Macchiato
Cappuccino
To heat up the cup before preparing
coee touch Cappuccino and Ameri-
cano icon simultaneously.
CAUTION! Hot water will flow out!
Afterwards throw away water and
continue with step 1.
8
i
* NESCAFÉ recommends to use milk
with at least 3 % fat.
INDIVIDUAL ADJUSTMENTS TO YOUR PERSONAL TASTE
 

Note: For Latte Macchiato &
Cappuccino, cup parameter
can not be adjusted
To adjust volume, please follow procedure below
You can adjust the strength of the coee by changing the amount of hot water:
Menu Espresso
type coee
Latte
Macchiato
Cappuccino
Black
coee
Mug-size
black coee
Parameters
(ml)
Standard
quantity
~60 ml ~140 ml ~200 ml
~40 ml ~70 ml ~100 ml
~120 ml ~210 ml ~300 ml
Minimum
quantity
Strongest
setting
Initial
setting
Weakest
setting
Maximum
quantity
When the selected menu icon stops
flashing green you can adjust the
amount of hot water.
9
3
The power button light changes to
orange. The selected menu icon lights
green. Coee extraction starts.
Put a cup in place. Touch and hold the
menu icon for the beverage you wish
to adjust for 2 seconds.
+/−
When the beverage reaches the
desired amount touch the menu icon
to stop. If you do not touch machine
will stop at the maximum water
level!
9
4
9
1
9
2
2 sec
9
i
Resetting initial beverage recipes
① Connect the power plug.
② Check that the power is OFF.
③ Touch and hold the Cappuccino
icon THEN the power button
simultaneously.
④ Release the buttons when all the
icon lights start flashing fast in
green.
⑤ Machine is now back to factory
settings.
⑥ Initial rinsing must be performed
(see page 5).
After changing the setting...
• Once you have changed the setting,
the new amount of hot water will
be used as the standard amount
when you make the next coee.
(The new amount of hot water is
not reset when you turn o the
power.)
• When a small cup is used, the cof-
fee may overflow the cup if you set
the amount of hot water too high.
• To adjust to a new amount of hot
water, repeat the above procedure
(the current setting will be over-
written).
( )
( )
( )