Nespresso Lattissima Touch - Coffee Preparation; Assembling;Disassembling of Rapid Cappuccino System (R.C.s.)

110 ml
40 ml
25 ml
EN
COFFEE PREPARATION
ASSEMBLING/DISASSEMBLING OF RAPID CAPPUCCINO SYSTEM R.C.S./
1. Lift the lever completely and insert the
capsule.
2. Close the lever and place a cup under the
coee outlet.
3. Press the Ristretto (25 ml), the Espresso (40 ml) or the Lungo (110 ml)
button. Preparation will stop automatically. To stop the coee ow or top
up your coee, press again.
4. Take the cup. Lift and close the lever
to eject the capsule into the used capsule
container.
1. Remove the milk container lid and unplug
milk aspiration tube.
4. Remove the milk spout by pulling it o.2. Remove the milk froth regulator knob by
turning it until
and pulling it up.
3. Remove Rapid Cappuccino System connector by
unlocking it from
to and pulling it o.
NOTE: during heat up, you can press any coee buttons. The coee will then ow automatically when the machine is ready.
12
7484_UM_LATTISSIMA_RESTYLE_Z3D.indb 12 19.03.15 09:54