Nespresso Lattissima Touch - Performing Factory Reset; FACTORY SETTINGS; Default Beverage Volumes

1 sec.
0
1
2
3
4
3 sec.
6. Now, within 15 sec, you can set the desired value by
pressing the corresponding button. They blink 3 times
rapidly to conrm new value.
7. The menu exits automatically and machine
returns to ready mode.
Clean
Descaling
EN
1. Place the water hardness
sticker under water for 1 second.
2. The number of red squares
indicates the water hardness
level.
WATER HARDNESS SETTING
Water hardness table
Level dH fH mg/L CaCo3
Latte Macchiato
0 <3 <5 <50
Cappuccino
1 >4 >7 >70
Warm milk froth
2 >7 >13 >130
+
Warm milk froth +
Latte Macchiato
3 >14 >25 >250
+
Warm milk froth +
Cappuccino
4 >21 >38 >380
4. Press the Latte Macchiato and Warm milk froth
buttons simultaneously for 3 seconds to enter Menu
mode: descaling and clean alerts start blinking.
3. Switch the machine ON.
NOTE: remove milk jug.
NOTE: the Menu mode exits
automatically after 30 sec. if no actions
are performed. It can be exit manually by
pressing the Latte Macchiatto and Milk
froth buttons simultaneously for
3 seconds.
5. Touch in a single continuous movement the following buttons:
Latte Macchiato ->Cappuccino ->Milk froth. The current water hardness
setting is indicated by the corresponding buttons (steady light).
23
7484_UM_LATTISSIMA_RESTYLE_Z3D.indb 23 19.03.15 09:54