Nespresso Lattissima Touch - PROGRAMMING COFFEE QUANTITY; Setting Espresso or Lungo Volume

3 sec.
30 min.
40° C
Clean
Descaling
EN
1. Disassemble the Rapid Cappuccino System. Refer to
section «Assembling/Disassembling of Rapid Cappuccino
system (R.C.S.)».
2. Rinse away carefully any milk residue with
potable water.
3. Soak all components in warm water
(approximately 40° C/104° F) together with soap
detergent for at least 30 minutes.
2. Press the Latte Macchiato and Warm milk froth buttons simultaneously for 3 seconds to enter
Menu mode: descaling and clean alerts start blinking.
1. Switch the machine ON.
4. Rinse with potable water and dry them with a
clean damp cloth.
HAND WASHING OF RAPID CAPPUCCINO SYSTEM R.C.S.
INFORMATION: when a dishwasher is not available, the R.C.S.
components can be washed by hand. In that case, the procedure must be
performed daily for a maximum eciency.
RESTORING QUANTITY TO FACTORY SETTINGS
NOTE: remove milk jug.
NOTE: the Menu mode exits automatically after
30 sec if no actions are performed or can be exited
manually by pressing the Latte Macchiatto and Milk
froth buttons simultaneously for 3 seconds.
19
7484_UM_LATTISSIMA_RESTYLE_Z3D.indb 19 19.03.15 09:54