Back to Title and Contents
4. In Recovery Mode, use the volume buttons
to highlight apply update from USBdrive.
5. Press the Power button to confirm the
selection.
6. Use the volume buttons to highlight the
correct update file on the USBdrive.
7. Press the Power button to confirm. The
CyberScope Air opens the Updater, installs
the update, and then restarts with the
update installed. This process can take 5 to
10 minutes. When complete, the message
'Install from USB drive completed with
status 0.'should show on the install line.
8. Use the volume keys and Power button to
select reboot system now. Your unit should
boot normally.
Software Management
124
To Next Page
Loading...