NetApp ASA C Series System Documentation

If the system-level diagnostics
tests…
Then…
Were completed without any
failures
There are no hardware problems and your storage system returns to
the prompt.
a. Clear the status logs by entering the following command: `sldiag
device clearstatus [-dev devtype
mb
slotslotnum]`
.. Verify that the log is cleared by entering the following command:
`sldiag device status [-dev devtype
mb
slotslotnum]`
+
The following default response is displayed:
+
----
SLDIAG: No log messages are present.
----
.. Exit Maintenance mode by entering the following command:
halt
.. Enter the following command at the Loader prompt to boot the
storage system:
boot_ontap
You have completed system-level diagnostics.
Resulted in some test failures Determine the cause of the problem.
a.
Exit Maintenance mode by entering the following command:
halt
b. Perform a clean shutdown and disconnect the power supplies.
c. Verify that you have observed all the considerations identified for
running system-level diagnostics, that cables are securely
connected, and that hardware components are properly installed
in the storage system.
d. Reconnect the power supplies and power on the storage system.
e. Repeat Steps 1 through 6 of Running hardware installation
diagnostics.
If the failures persist after repeating the steps, you need to replace the hardware.
Run device failure diagnostics
Running diagnostics can help you determine why access to a specific device becomes
intermittent or why the device becomes unavailable in your storage system.
1.
At the storage system prompt, switch to the LOADER prompt:
halt
2.
Enter the following command at the LOADER prompt: boot_diags
1454

NetApp ASA C Series Specifications

General

Brand	NetApp
Model	ASA C Series
Category	Storage
Language	English