NetApp ASA C Series System Documentation

2. Verify that the hot-added shelf is cabled correctly.
If any cabling errors are generated, follow the corrective actions provided.
NetApp Downloads: Config Advisor
3. If you disabled automatic drive assignment as part of the preparation for this procedure, you need to
manually assign drive ownership and then re enable automatic drive assignment, if needed.
Otherwise, you are done with this procedure.
Complete the hot-add
Complete the hot-add
If you disabled automatic drive assignment as part of the preparation for the NS224 drive
shelf hot-add, you need to manually assign drive ownership and then reenable automatic
drive assignment if needed.
Before you begin
You must have already cabled your shelf as instructed for your HA pair.
Cable a drive shelf for a hot-add
Steps
1.
Display all unowned drives: storage disk show -container-type unassigned
1511

NetApp ASA C Series Specifications

General

Brand	NetApp
Model	ASA C Series
Category	Storage
Language	English