7. If you disabled automatic drive assignment when you removed ownership from the drives, reenable it:
storage disk option modify -autoassign on
You run the command on both controller modules.
8. You have the option of reconfiguring the non-dedicated RoCE capable ports for networking use, by
completing the following substeps.
Otherwise, you are done with this procedure.
a.
Verify the names of the non-dedicated ports, currently configured for storage use:
storage port
show
You can enter the command on either controller module.
The non-dedicated ports configured for storage use are displayed in the output as
follows:
If your HA pair is running ONTAP 9.8 or later, the non-dedicated ports display
storage
in the Mode column.
If your HA pair is running ONTAP 9.7 or 9.6, the non-dedicated ports, which display
false in the Is Dedicated?` column, also display enabled in the State column.
b. Complete the set of steps applicable to the version of ONTAP your HA pair is running:
If your HA pair is running… Then…
ONTAP 9.8 or later i. Reconfigure the non-dedicated ports for networking use, on the
first controller module:
storage port modify -node node
name -port port name -mode network
You must run this command for each port you are
reconfiguring.
ii. Repeat the above step to reconfigure the ports on the second
controller module.
iii. Go to substep 8c to verify all port changes.
ONTAP 9.7 i. Reconfigure the non-dedicated ports for networking use, on the
first controller module:
storage port disable -node
node name -port port name
You must run this command for each port you are
reconfiguring.
ii. Repeat the above step to reconfigure the ports on the second
controller module.
iii. Go to substep 8c to verify all port changes.
1529
To Next Page
Loading...
Need help?
General
