Step Perform on each controller
Use the Cat 6 RJ45 cable to cable the e0c through e0f ports to your
host network:
Cable the e0M ports to the management network switches with the
RJ45 cables
.
DO NOT plug in the power cords at this point.
2. To complete setting up your system, see
Step4: Completing system setup and configuration.
Option 4: Cable a switched cluster, Ethernet configuration
RJ45 ports and management ports on the controller modules are connected to switches.
The cluster interconnect ports are cabled to the cluster interconnect switches.
Contact your network administrator for information about connecting the system to the switches.
Be sure to check the illustration arrow for the proper cable connector pull-tab orientation.
As you insert the connector, you should feel it click into place; if you do not feel it click, remove
it, turn it around and try again.
948
To Next Page
Loading...
Need help?
General
