NetApp ASA C Series System Documentation

The node begins to boot as soon as it is completely installed into the chassis.
5.
Interrupt the boot process to stop at the LOADER prompt by pressing Ctrl-C when you see
Starting
AUTOBOOT press Ctrl-C to abort….
If you miss this message, press Ctrl-C, select the option to boot to Maintenance mode, and then halt the
node to boot to LOADER.
6. Although the environment variables and bootargs are retained, you should check that all required boot
environment variables and bootargs are properly set for your system type and configuration using the
printenv bootarg name command and correct any errors using the setenv variable-name
<value>
command.
a. Check the boot environment variables:
▪
bootarg.init.boot_clustered
▪
partner-sysid
▪
bootarg.init.flash_optimized for AFF C190
▪
bootarg.init.switchless_cluster.enable
b.
If External Key Manager is enabled, check the bootarg values, listed in the
kenv ASUP output:
▪
bootarg.storageencryption.support <value>
▪
bootarg.keymanager.support <value>
▪
kmip.init.interface <value>
▪
kmip.init.ipaddr <value>
▪
kmip.init.netmask <value>
▪
kmip.init.gateway <value>
c.
If Onboard Key Manager is enabled, check the bootarg values, listed in the
kenv ASUP output:
▪
bootarg.storageencryption.support <value>
▪
bootarg.keymanager.support <value>
▪
bootarg.onboard_keymanager <value>
d.
Save the environment variables you changed with the
savenv command
e.
Confirm your changes using the
printenv variable-name command.
7. Boot the recovery image:
boot_recovery ontap_image_name.tgz
If the image.tgz file is named something other than image.tgz, such as boot_recovery
9_4.tgz
, you need to include the different file name in the boot_recovery command.
The system boots to the boot menu and prompts you for the boot image name.
8. Enter the boot image name that is on the USB flash drive:
image_name.tgz
961

NetApp ASA C Series Specifications

General

Brand	NetApp
Model	ASA C Series
Category	Storage
Language	English