If your system is in… Then…
A stand-alone configuration You can begin using your system after the node reboots.
An HA pair
After the impaired node is displaying the Waiting for Giveback…
message, perform a giveback from the healthy node:
a. Perform a giveback from the healthy node:
storage failover giveback -ofnode
partner_node_name
This initiates the process of returning ownership of the impaired
node’s aggregates and volumes from the healthy node back to the
impaired node.
If the giveback is vetoed, you can consider
overriding the vetoes.
ONTAP 9 High-Availability Configuration Guide
b. Monitor the progress of the giveback operation by using the
storage failover show-giveback command.
c. After the giveback operation is complete, confirm that the HA pair
is healthy and that takeover is possible by using the
storage
failover show
command.
d. Restore automatic giveback if you disabled it by using the
storage failover modify command.
Boot the recovery image - AFF C190
You must boot the ONTAP image from the USB drive, restore the file system, and verify
the environmental variables.
Steps
1. From the LOADER prompt, boot the recovery image from the USB flash drive:
boot_recovery
The image is downloaded from the USB flash drive.
2. When prompted, either enter the name of the image or accept the default image displayed inside the
brackets on your screen.
3.
Restore the
var file system:
963
To Next Page
Loading...
Need help?
General
