EasyManuals Logo

NetApp E Series Replacing Guide

NetApp E Series
22 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
Attention: Possible loss of data access – Make sure to record the exact location of each drive before removing it.
5.
Remove the drives from the drive drawer:
a. Gently pull back the orange release latch that is visible on the center front of each drive. The following image shows the
orange release latch for all 12 drives in a drive drawer.
0
Orange release latch for drive 0
Removing a drive drawer
11

Table of Contents

Other manuals for NetApp E Series

Preview: Manual
Manual133 pages
Preview: Install And Setup
Install And Setup16 pages
Preview: Hardware Maintainence Manual
Hardware Maintainence Manual397 pages
Preview: Installation And Setup Instructions
Installation And Setup Instructions2 pages
Preview: Installation Manual
Installation Manual24 pages
Preview: Maintaining
Maintaining90 pages
Preview: Install
Install16 pages

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NetApp E Series and is the answer not in the manual?

NetApp E Series Specifications

General IconGeneral
Form Factor2U, 4U
Drive TypesSSD
Host InterfaceSAS, iSCSI, FC, IB
RAID LevelsRAID 0, 1, 5, 6, 10
Operating System CompatibilityWindows, Linux, VMware
Management SoftwareSANtricity

Related product manuals