EasyManuals Logo

NetComm N300 User Manual

NetComm N300
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
ADSL2+/3G Wireless N300 4-Port Modem Router YML15WN
30 www.netcomm.com.au
MAC lter
This screen appears when Media Access Control (MAC) Filter is selected. This option allows access to be restricted based upon the unique
48-bit MAC address.
To add a MAC Address lter, click the Add button shown below.
To delete a lter, select it from the table below and click the Remove button.
Option Description
MAC Restrict Mode
Disabled – Disables MAC ltering
Allow: Permits access for the specied MAC addresses
NOTE: Add a wireless device’s MAC address before clicking the Allow radio button or else
you will need to connect to the Router’s web user interface using the supplied yellow Ethernet
cable and add the wireless device’s MAC address.
Deny Rejects access for the specied MAC addresses
MAC Address Lists the MAC addresses subject to the MAC Restrict Mode. The Add button prompts an
entry eld that requires you type in a MAC address in a two-character, 6-byte convention: xx:
xx:xx:xx:xx:xx where xx are hexadecimal numbers. A maximum of 60 MAC addresses can be
added.
Enter the MAC address on the screen below and click Save/Apply.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NetComm N300 and is the answer not in the manual?

NetComm N300 Specifications

General IconGeneral
Frequency Band2.4GHz
LAN Ports4 x 10/100Mbps
WAN Ports1 x 10/100Mbps
ModelN300
Wireless StandardsIEEE 802.11n
Data Transfer Rate300 Mbps
SecurityWPA, WPA2, WEP
Antenna2 x external

Related product manuals