NB604N – ADSL2+ Wireless N300 Modem Router
NetComm NB604N – ADSL2+ Wireless N300 Modem
Router
In the case of a PPPoE connection, the following options are available:
PPP Username and Password
The username and password required to access the service
A name to identify the configured service
Select the authentication method in use on the service
Set the Maximum Transmit Unit (MTU) size for the connection
Select to enable or disable Network Address Translation (NAT) for this connection
Select to enable Fullcone NAT on the connection.
Select to enable dial on demand mode. Enter the idle time to wait before disconnecting the service.
Select to enable PPP IP Extension on the connection
Enter a static IP Address to utilise with the connection
Select to enable IPv6 support for the connection. This enables the NB604N to Request Prefix Delegation and
request an IPv6 Address.
Enable IGMP Multicast Proxy
Enable IGMP Proxy mode on the connection. This is commonly used for IPTV.
Enable MLD Multicast Proxy
Enable MLD Proxy mode. This is the IPv6 equivalent of IGMP proxy mode.
Click Next once the connection configuration details have been entered.
(a)
Select the Default Gateway Interface to use for the connection and click Next
(b)
Select the DNS Server Interface to use for the connection and click Next
(c)
Review the configured functions of the connection and click Save/Apply to save the new WAN Service
connection.
To Next Page
Loading...
Need help?
General
