Wireless Cable Gateway CG3000D/CG3100D User Manual
Wireless Configuration 2-7
v1.0, September 2009
Configuring WEP (Wired Equivalent Privacy) Wireless Security
Note: If you use a wireless computer to configure wireless security settings, you will be
disconnected when you click Apply. Reconfigure your wireless computer to match
the new settings, or access the gateway from a wired computer to make further
changes.
To configure WEP data encryption:
1. Log in to the gateway as described in “Logging In to Your Gateway” on page 1-4.
2. In the main menu, under Setup, select Wireless Settings.
3. In the Wireless Settings screen, depending on the encryption strength that you want, select one
of these options:
• WEP (Wired Equivalent Privacy) 64-bit encryption
• WEP (Wired Equivalent Privacy) 128-bit encryption
Settings for WEP encryption are shown in the following figure (which is the bottom part of the
Wireless Settings screen).
Figure 2-2
4. Select the WEP security encryption from the Authentication drop-down list. Select
Automatic, Open System or Shared Key. The default is Automatic.
To Next Page
Loading...
