NETGEAR CG3100Dv3 - Technical Specifications

Default Settings and Technical Specifications
49
NETGEAR Wireless Cable Gateway CG3100Dv3
Technical Specifications
The following table describes the technical specifications for the gateway.
Wireless Wireless communication Enabled
SSID name As shown on the product label.
Security WPA/WPA2
The default WPA/WPA2 passphrase is as shown on
the product label.
Broadcast SSID Enabled
Transmission speed Auto
1
Country/region EU
RF channel Auto
Operating mode n, g, and b
Data rate Best
Output power Full
Access point Enabled
Authentication type Open System
Wireless card access list All wireless stations allowed
1. Maximum Wireless signal rate derived from IEEE Standard 802.11 specifications. Actual throughput will
vary. Network conditions and environmental factors, including volume of network traffic, building materials
and construction, and network overhead, may lower actual data throughput rate.
Technical Specifications
Network protocol and
standards compatibility
Data and Routing Protocols: TCP/IP, DHCP server and client, DNS relay, NAT
(many-to-one),
TFTP client, VPN pass through (IPSec, PPTP)
Power adapter • Europe (input): 230V, 50 Hz, input
• All regions (output): 12 V DC @ 1.5A output 18W maximum or
12 V DC @ 2.5A output 30W maximum
Physical specifications • Dimensions: 7.5 by 3.8 by 1.4 in (195 by 112 by 33 mm)
• Weight: 0.65 lb (0.28 kg)
Environmental • Operating temperature: 32° to 140° F (0° to 40° C)
• Operating humidity: 90% maximum relative humidity, noncondensing
• Electromagnetic emissions: Meets requirements of: FCC Part 15 Class B.
Factory Default Settings (Continued)