Advanced Settings
103
N600 Wireless Dual Band Gigabit ADSL2+ Modem Router DGND3700v2
Disable Wireless Client Association. If your wireless modem router is the repeater,
selecting this check box means that wireless clients cannot associate with it. Only LAN
client associations are allowed.
- If you are setting up a point-to-point bridge, select this check box.
- If you want all client traffic to go through the other access point (repeater with wireless
client association), leave this check box cleared.
• Wireless MAC of this router. This field displays the MAC address for your wireless
modem router for your reference. You will need to enter this MAC address in the
corresponding Wireless Repeating Function screen of the other access point you are
using.
• Wireless Repeater. If your wireless modem router is the repeater, select this radio
button.
Repeater IP Address. If your wireless modem router is the repeater, enter the IP
address of the other access point.
Base Station MAC Address. If your wireless modem router is the repeater, enter the
MAC address for the access point that is the base station.
• Wireless Base Station. If your wireless modem router is the base station, select this
radio button.
Disable Wireless Client Association. If your wireless modem router is the base station,
selecting this check box means that wireless clients cannot associate with it. Only LAN
client associations are allowed.
Repeater MAC Address (1 through 4). If your wireless modem router is the base
station, it can act as the “parent” of up to four other access points. Enter the MAC
addresses of the other access points in these fields.
Set Up the Base Station
The wireless repeating function works only in hub and spoke mode. The units cannot be
daisy-chained. You have to know the wireless settings for both units. You have to know the
MAC address of the remote unit. First, set up the base station, and then set up the repeater.
To set up the base station:
1. Set up both units with exactly the same wireless settings (SSID, mode, channel, and
security). Note that the wireless security option has to be set to None or WEP.
To Next Page
Loading...
Need help?
General
