To Next Page

To Previous Page

USB Printer Control

N600 Wireless Dual Band Gigabit ADSL2+ Modem Router DGND3700v2

Control Center Configuration

Select Tools > Configuration to display the following screen:

Automatically execute when logging on Windows. Select this check box to have the utility

start automatically when you are logged in to Windows.

Timeout. Specify the time-out value for holding the USB resource when it is not in use.

Language. Select the display language for this utility

USB Printer

The first time you use a printer, you need to click Connect. You might be asked to install the

driver for this printer. After the driver is installed, the printer status changes to Available.

Note: Some USB printers (for example: HP and Lexmark printer) request

that you do not connect the USB cable until you are prompted by the

installation software.

If the USB printer is detected and connected automatically, you need to disconnect the

printer

, and then wait for the prompt asking you to click Connect.

NETGEAR DGND3700v2 User Manual

Other manuals for NETGEAR DGND3700v2