6. Specify a password and log in again using your new password
You can now use the CLI to manually congure the switch, including the IP
address.
To use the ezcong utility, continue with the next step.
7. At the next command prompt, type ezcong and press Enter.
The ezcong utility is now running on the switch.
Find the DHCP-assigned IP address
By default, the switch functions as a DHCP client and gets its IP address from a
DHCP server in the network. To nd the assigned IP address of the switch’s OOB
port or management interface (which can be any of the Ethernet ports), connect a
computer or VT100/ANSI terminal to one of the console ports on the switch.
1. Make sure that the switch is connected to a DHCP server.
2. Set up a console connection with the switch.
For information about setting up a console connection, see Steps 1 through
6 in Access the CLI to congure the switch. After you are logged in and at the
CLI command prompt, continue with the next step.
3. At the command prompt, do one of the following:
• To nd the IP address of the OOB port (which is also referred to as the
service port), type the show serviceport command, and press Enter.
• To nd the IP address of the management interface, enter the privileged
EXEC mode by typing enable, type the show ip management
command, and press Enter.
The IP address that is assigned by the DHCP server displays.
4. Log in to the switch’s AV UI or main UI by launching a web browser and
entering http://<ipaddress> in the address eld:
• OOB port: Enter the IP address that is assigned to the OOB port.
• Any Ethernet network port: Enter the IP address that is assigned to the
management interface.
To Next Page
Loading...
