genie Advanced Home
41
N600 Wireless Dual Band Router WNDR3400v2
LAN Setup
The LAN Setup screen allows configuration of LAN IP services such as Dynamic Host
Configuration Protocol (DHCP) and Routing Information Protocol (RIP).
The router is shipped preconfigured to use private IP addresses on the LAN side and to act
as a DHCP server
. The router’s default LAN IP configuration is:
• LAN IP addre
ss: 192.168.1.1
• Subnet
mask: 255.255.255.0
These addresses are part of the designated priva
te address range for use in private networks
and should be suitable for most applications. If your network has a requirement to use a
different IP addressing scheme, you can make those changes in the LAN Setup screen.
To change the LAN settings:
Note: If you change the LAN IP address of the router while connected
through the browser, you will be disconnected. You have to open a
new connection to the new IP address and log in again.
1. Select Advanced > Setup > LAN Setup to display the following screen:
2. Enter the settings that you want to customize. These settings are described in the following
section, LAN Setup Screen Settings.
3. Click App
ly to save your changes.
To Next Page
Loading...
Need help?
General
