NETGEAR Nighthawk 5G Mobile Hotspot Pro

6. To change the global WiFi settings, adjust the WiFi standby time or the WiFi range.
7. Click the Apply button.
Your settings are saved.
When you change your profile options (including disabling or enabling either WiFi
network), any devices connected to the mobile hotspot are disconnected and might
need to be reconnected.
Configure Always-On WiFi
Always-On Wifi will route all traffic over the Ethernet WAN. If the Ethernet connection
fails, the device automatically switches to LTE.
Note: In order to enable Always-On WiFi, you must disable Data Offloading.
To configure Always-On WiFi:
1.
On the LCD Home Screen, click Always-on Wifi
2.
Click the Off button to change it to On.
Always-On WiFi is enabled.
Enable the Data Saver From a Web Browser
You can implement the Data Saver to connect your Mobile Router to your local WiFi or
Ethernet network to offload traffice and help conserve your AT&T data plan.
To enable Ethernet data offloading:
1. From a computer that is connected to your network, launch a web browser.
2.
Enter http://attwifimanager or http://192.168.1.1.
A login page displays.
3. Enter the administrator login password.
The password is case-sensitive.
The dashboard displays.
4.
Select SETTINGS > Setup > Data Offloading.
The Data Saver page displays.
5. Set the Data Saver select to ON
6. Select the Enable check box.
7.
Select the Ethernet Offloading selection.
By default, Ethernet Offloading is selected.
User Manual53Specify Mobile Hotspot Network
Settings
Nighthawk 5G Mobile Hotspot Pro