NETGEAR Nighthawk 5G Mobile Hotspot Pro

Enable IP Pass-Through Mode
To turn off the mobile hotspot functionality and assign the network IP address directly
to the attached device, enable IP pass-through.
If you make this change, the attached device restarts using a different driver
configuration.
WARNING: If you enable this feature, WiFi is disabled and you must use a USB cable
to tether the device.
Note: This feature is available to Windows computer users. If you are a Mac user, do
not enable this option because you will be unable to access your device.
To enable IP pass through mode:
1. From a computer that is connected to your network, launch a web browser.
2.
Enter http://attwifimanager or http://192.168.1.1.
A login page displays.
3. Enter the administrator login password.
The password is case-sensitive.
The dashboard displays.
4. Select SETTINGS > Setup > Mobile Router Setup.
The ROUTER SETUP page displays.
5. Select the IP PASSTHROUGH ON button.
The default selection is AUTO.
Enable VPN Pass-Through Mode
To connect to a corporate network using VPN, you must first enable VPN connections
(pass-through).
To enable VPN pass-through:
1.
Enter http://attwifimanager or http://192.168.1.1.
A login page displays.
2. Enter the administrator login password.
The password is case-sensitive.
User Manual58Specify Mobile Hotspot Network
Settings
Nighthawk 5G Mobile Hotspot Pro