NETGEAR Nighthawk AC1900 R7000 User Manual

2
Install Your Router
Make sure that your Internet service is active before you install your
router.
 To install your router:
1. Attach the antennas.
a. Align the antennas with the antenna posts on the router.
b. Attach the antennas on the threaded antenna posts.
c. Position the antennas for the best WiFi performance.
NETGEAR recommends that the center antenna be vertical
and that you aim the others outward at 45 degree angles, as
shown.
2. Prepare your modem.
a. Unplug your modem’s
power.
b. If the modem has a battery
backup, remove its batteries.
c. If your modem was already
connected to another router,
disconnect the cable
between your modem and
that router.
Internet
DSL or cable
Modem

NETGEAR Nighthawk AC1900 R7000 Specifications

General

WiFi Performance	AC1900 (600 + 1300 Mbps)
WiFi Range	Very large homes
Beamforming	Yes
Antennas	3 external antennas
Dynamic QoS	Yes
VPN Support	Yes
Guest Network	Yes
Parental Controls	Yes
Dimensions	11.22 x 7.26 x 1.97 in (285 x 184.5 x 50 mm)
WiFi Technology	802.11ac
Processor	1GHz Dual Core
Ethernet Ports	5 (1 WAN & 4 LAN) Gigabit Ethernet ports
USB Ports	1 x USB 3.0, 1 x USB 2.0
Memory	128 MB Flash and 256 MB RAM
Security	Double Firewall Protection (SPI and NAT)
Weight	1.65 lb (750 g)