To connect your cable modem to a router after installation and activation:
1.
Reboot the cable modem by unplugging the power cable from the cable modem
and plugging it back in.
Wait for the Internet LED to stop blinking and light solid white.
2. Use an Ethernet cable to connect the Ethernet port on the cable modem to the WAN
or Internet port on the router.
3. Power on the router.
4. Wait until the router is ready.
5. Connect a computer to the router.
For more information about how to set up your router, see the documentation that
came with your router.
User Manual12Hardware Setup
Nighthawk CM2000 2.5 Gbps Ultra-High Speed Cable Modem
To Next Page
Loading...
