NETGEAR NIGHTHAWK CM2000 User Manual

Figure 2. Rear panel
Viewed from top to bottom, the back panel contains the following components:
•
Reset button. Pressing the Reset button resets the cable modem. If the Reset button
is pressed for at least seven seconds, the Power LED blinks white and the cable
modem returns to its factory settings.
•
Ethernet port. For installation and activation, connect a computer to the Ethernet
port. After you install your cable modem and activate your Internet service, you can
disconnect your computer and connect a router to the Ethernet port.
User Manual7Hardware Setup
Nighthawk CM2000 2.5 Gbps Ultra-High Speed Cable Modem

NETGEAR NIGHTHAWK CM2000 Specifications

General

Cables included	AC, LAN (RJ-45)
Quick start guide	Yes
WAN connection	Ethernet (RJ-45)
Ethernet LAN (RJ-45) ports	1
Product color	Black
DC input voltage	12 V

Weight and Dimensions

Depth	172 mm
Width	94 mm
Height	208 mm
Weight	482 g