Orbi AC satellite LED behavior
An Orbi AC satellite has a Power LED on the back and a Ring LED on the top.
The following table describes the LED behavior.
Note: The Orbi AC satellite model RBW30 does not include a Power LED.
Table 3. LED behavior for Orbi AC satellite
DescriptionLED color
Router is booting or Sync (WPS) button has been pushed.Pulsing white
Internet connection is established.Solid blue
Unable to connect to internet.Solid amber
The satellite’s firmware is corrupted.Pulsing red
88% to 99% of data is used.White and orange
pulse
100%+ of data is used.White and red pulse
Power is not suppliedOff
Place your satellite
Your satellite must be within range of your router’s WiFi signal in order for it to sync with
the router. Use the satellite’s ring LED to help you determine where to place your satellite.
Sync an add-on satellite
If you already set up the router and are adding an optional add-on satellite (sold
separately), follow these steps.
To sync your add-on satellite:
1. Place your satellite.
Make sure that your satellite is within range of your router’s WiFi signal.
2. Connect the satellite to a power source.
User Manual142Set Up and Manage an Optional
Orbi Satellite
Orbi 4GX Router Model LBR1020
To Next Page
Loading...
