Advanced Settings
118
Trek N300 Travel Router and Range Extender PR2000
6. Scroll down and click the Set Up Access List button.
7. On the Wireless Card Access List screen, click the Add button.
The Wireless Card Access Setup screen opens and displays a list of currently active
wireless cards and their Ethernet MAC addresses.
8. If the computer or device you want is in the Available Wireless Cards list, select that radio
button; otherwise, type a name and the MAC address.
You can usually find the MAC address on the label of the wireless device.
Tip: Y
ou can copy and paste the MAC addresses from the Attached
Devices screen into the MAC Address field of this screen. To do this,
use each wireless computer to join the wireless network. The
computer then appears in the Attached Devices screen.
For more information about the attached devices, see Attached Devices on page 48.
9. Click the Add button.
The screen changes back to the list screen.
10. Add each computer or device that you want to allow to connect wirelessly
.
11. Select the T
urn Access Control On check box.
12. Click the Apply button.
To edit a wireless device or delete it from the access list:
1. Launch your browser from a computer or wireless device that is connected to the T
rek.
2. Enter www
.routerlogin.net or www.routerlogin.com in the web browser address bar.
The login screen displays.
3. Enter the T
rek user name and password.
The user name is admin.
The default password is password. The user name and
password are case-sensitive.
To Next Page
Loading...
Need help?
General
